Pulseaudio Setup

From Ghpsdr3 SDR project
Revision as of 16:51, 12 November 2011 by Dl6kbg (Talk | contribs)

Jump to: navigation, search

To run the softrock server use:

pavucontrol

to choose the default pulse audio sources:

For TX Audio

Softrock:IQ = shared ID for use with libusb Analog Stereo

and for RX Audio:

Softrock:IQ = shared ID for use with libusb Analog Stereo

You also need to run pulse in network mode. Use:

paprefs

to set up network access by checking the various option boxes.

Pulseaudio Setup independant on a X-Server installation

Make sure you add your username to the following system groups:

pulse, pulse-access, audio.
sudo nano -w /etc/group

Example for the user dl6kbg:

audio:x:29:pulse,dl6kbg
pulse:x:119:dl6kbg
pulse-access:x:120:dl6kbg
sudo nano /etc/default/pulseaudio

change settings to:

PULSEAUDIO_SYSTEM_START=1
DISALLOW_MODULE_LOADING=0
sudo nano /etc/pulse/system.pa

and add:

load-module module-native-protocol-tcp auth-anonymous=1

Restart pulseaudio:

sudo /etc/init.d/pulseaudio restart

or restart the system and fire up the softrock server. Pulseaudio runs now in systemwide mode and your softrock server should be able to establish a connection to your following dspserver.

In order to use 96000 or 192000, you will need to configure pulse audio by editing:

/etc/pulse/daemon.conf

or better, copy the file to:

~/.pulse/daemon.conf

and then edit the file there, if you run your pulseadio system in user mode.